Skip to main content

GCU-10

Generator Control Unit

The GCU-10 Generator Control Unit is an universal economical programmable genset controller. Equipped with high illuminating LED with universal graphical interface helps to notify the operator the generator status. Optional relay module GCU-11R (12V/24V) helps to simplify the wiring and connection process.

Manual

Features

  • Microprocessor Based Design
  • Universal LED Graphic Interface, Displays Generator Status and Failures
  • Modular Design, Quick Installation
  • Programmable Engine & Generator Controls Adapts Easily To Any Type Generator Set.
  • Waterproof Front Panel With UV Protection
  • Provide IDLE control For Elec. Governors
  • Five Adjustable Time Delay Potentiometers
  • Five DIP Switches For Specification Setting

Specifications

Model NO. GCU-10
DC Supply Voltage 9 to 36 VDC
Alternator Input Range Voltage 5~300 VDC
Frequency 50~60 Hz
Fuel Solenoid Signal Output 5 Amp @ 12/24 VDC
Start Signal Output 5 Amp @ 12/24 VDC
Warm up Signal Output 5 Amp @ 12/24 VDC
Accessory " ON " Output 5 Amp @ 12/24 VDC
Idle Control Conductor Capacity 5 Amp @ 12/24 VDC
Power Consumption Under 3 VA on Auto
Protection & Alarm Status Indicators
  • Start Failure
  • High Water Temperature
  • Low Oil Pressure
  • Overspeed
  • Underspeed
  • Emergency Stop
  • Extra Prog. Input
  • Low Battery Voltage
Adjustable Timers Engine Pre-Heat : 2~30 sec.
Starter Cranking Time : 1~15 sec.
Energize to STOP : 1~30 sec.
Engine Idle (Governor) : 0~300 sec.
Engine Cool-down : 0~300 sec.
Environment Operation Temperature : -20~70 °C
Relative Humidity : Maximum 90%
Panel Installation Cut-Out 66.0 x 66.0 ±0.5 mm
Dimensions 72.0 (L) x 72.0 (W) x 50.0 (H) mm
Weight 166 g ±2%

*Note : All features & specifications subject to change without notice.

Dimensions